July/August 2010
Ordered and fitted the brake line run from the master cylinder area to the rear nearside quarter. Instead of buying a run of pipe and flaring the ends as we did with a previous kit build we bought a ‘ready made’ replacement set from Machine 7. This kit comes with all of the pipes at the correct length (for a VW Beetle at least) including the correct fittings.
We had to cut and reflare the longest run of pipe which connects the master cylinder to the T-piece at the rear of the car (see photos) because it was made for a full length VW chassis – the Chesil chassis is 10 and 3 quarter inches shorter than standard. In photo 3 (far right – not added yet) you will notice the 1 way brake connector, these do not seem to be made any more (or at least I couldn’t find a single place in the UK that could supply them) so you will need to keep the item from your donor chassis, ours cleaned up nicely. We fitted the brakeline to the chassis with stainless steel rivets and brass P-clips at every 20 centimetres so it complies with the IVA requirements. You will notice the ‘kink’ in the run in photo 1, this is necessary so the line avoids the pedals. We bent the pipe by hand but for the tighter bends used a special pipe bender which you can get from any half-decent hardware shop.


We also fitted the fuel line. You can install this by attaching the pipe to the outside of the chassis but the original method is to run down the inside of the chassis tunnel in the centre of the car. The fuel line runs from the nearside rear fork to the chassis frame head. To prevent the pipe rattling in the tunnel we split rubber fuel hose and slipped it over the brakeline; rubber grommets were used in all holes. To be honest fitting the line inside the tunnel was a bit of a nightmare and took about 2 hours but is much more protected than it would be outside the car and looks neater.



To next section: Front Suspension.